L1 Bay2-specific setup

Connect Ethernet cable to a network port underneath the printer. Lower right port in the right panel should be used (it is labeled "Slicer").

Network configuration details

Configuration parameter Value Comment
IP x Dedicated to the workstation; can be used in Bay 2 area; The IP address is registered in the Bay 2 scanner host for DICOM transfer
Subnet Mask x
Gateway x

Test connection from MRI host computer

To check the connection, press Ctrl+Esc on the MRI host to pop up windows menu, choose "Run...," type

cmd

and hit Enter. Once the command terminal opens, type:

ping x

If the network is configured properly, you will see responses like:

Reply from x bytes=32 time<1ms TTL=64

If there is an issue, the terminal shows network unreachable error.

results matching ""

    No results matching ""